Industry 02

Medtech

Enclosures, chassis and structural parts for Medtech equipment, where the documentation matters as much as the part.

A healthcare worker in blue scrubs and a plastic apron pointing at a ventilator's screen beside a patient in a hospital bed, with a colleague in the foreground.

The challenge

Medtech equipment has long life cycles, and every change has to go through a regulated process. Moving a part to a new supplier means verifying it all over again. So the part has to come out the same in ten years’ time as it does today.

How we work

We cast the housing, machine the interfaces, apply chromate conversion and powder coating, and fit seals and cable glands. You qualify one supplier instead of several, and we work to the quality requirements you set.

Measuring probe with a star stylus checking the edge of a hole in a bright, machined aluminium part.

Requirements we work to

  • A documented process, with changes notified before they are made
  • Traceability from melt batch to delivered part
  • First article inspection (FAI) and inspection reports
  • Clean surfaces and careful handling
  • Die maintenance over the full product life

Typical parts

  • Instrument enclosures
  • Structural chassis
  • Heat-dissipating electronics housings
  • Brackets and mounts

Contact us

We start with your drawing

Send it over, ideally before the design is frozen. That way we can suggest changes while they’re still cheap to make.

We accept STEP, IGES and 2D drawings, and we’re happy to sign an NDA before you send anything.