Quality & environment

Quality you can measure

We measure parts against the drawing and show you the results. Our management system is certified to ISO 9001 and ISO 14001, and we cast in recycled aluminium alloy.

Cast aluminium ingots stacked layer upon layer, seen at an angle towards the corner of the stack.

Quality & environment

Environmental management in practice

01

Recycled alloy

We cast in recycled aluminium alloy. Remelting aluminium takes only a fraction of the energy needed to produce it from ore.

02

Hydropower in Sölvesborg

The electricity we use in Sölvesborg comes mainly from hydropower, which has a far lower carbon footprint than fossil-based power.

03

Ongoing investment

Since 2018 we have invested in new die-casting machines, CNC machines and finishing lines. Newer equipment generally uses less energy per part.

Measuring probe with a star stylus checking the edge of a hole in a bright, machined aluminium part.

Certification

Quality in production

Quality assurance starts at the tool design stage and follows the part all the way through production, with first article inspection (FAI), CMM measurement, traceability and inspection reports as agreed.

Our metrology lab has two coordinate measuring machines (CMMs), a Hexagon Global S 9.15.8 Green and a CE Johansson Cordimatic 6000, both running PC-DMIS.

01

Design review

We review casting geometry and machined features (DFM) before the die is ordered.

02

Trial casting

First-off samples are measured against the drawing and documented.

03

Process control

Fixed process parameters for each part number, and robot-served cells that run every cycle the same way.

04

Measurement

CMMs running PC-DMIS, with inspection reports as agreed.

05

Traceability

From melt batch to delivered part.

ISO 9001 · ISO 14001

Certification

Our management system is certified to ISO 9001 and ISO 14001 by A3Cert.

ISO 9001
Certificate number:
336
Valid until:
2027-02-26
Certification body:
A3Cert
ISO 14001
Certificate number:
336
Valid until:
2027-02-26
Certification body:
A3Cert

Documents

Questions about quality and the environment

Operator in a cap at a machining centre, one hand on the machine door and the other at the control panel.

Responsibility on the shop floor

The person running the machine is also responsible for the process. We keep training needs under regular review, because experienced people are what make long customer relationships possible.

Contact us

We start with your drawing

Send it over, ideally before the design is frozen. That way we can suggest changes while they’re still cheap to make.

We accept STEP, IGES and 2D drawings, and we’re happy to sign an NDA before you send anything.